Cast Bellow Seal Globe Valve

Forged Bellow Seal Globe Valve

Comparison Between Bellow Seal & Traditional Valves
Bellow Seal Valves | Piston Valves | Conventional Valves | |
---|---|---|---|
Primary stem seal | Metallic Bellow | Piston Ring | Gland Packing |
Secondary stem seal | Gland packing | None | None |
Stem Leakage | Not Possible since Metallic Bellows are designed to last several thousands cycles | Occurs as soon as the ring wear out. | Very common. Due to friction between stem occurs within a few cycle no matter which make valve or quality of gland packing |
Packing Replacement | Not applicable | Rings need to be changed frequently | Packing needs to be replaced very often |
Replacement Cost | Not applicable | Very High | High |
Media Loss | Zero Loss. As the isolation is by metallic bellows, leakage (in ppm) is not possible. | Large in case of leaks | Considerable amount through gland leakages. Normally large amount when leakage remains unattended. |
Equipment Downtime | Nil | Very High for replacing rings | Very high for replacing gland packing |
Maintanance Cost often | Nil | High as rings need to be changed atleaset once in six months | Very high, Gland packing needs to be replaced / repacked. The cost along with equipment down tme, man hours spent act is very high. |
Valve Life | High-in years | Low | VeryLow - in -months. Due to leakage through gland, certain parts erode, making the valve irreparable after some months. |
Safety | Can be used safely for almost any media | Can be used for limited medi like steam, hot water | Highly unsafe when the media is hazardous / poisonous |
Cost | Comparatively higher initially but lowest total cost of ownership | High compared to the benefits | Initially low but very high after some years if cost pf packing, down time, man-hours spent, number of valves replaced act. are taken in to account. |
Список продукции
- сильфонным уплотнением клапан
- Клапан запорный
- Задвижка
- Клапан обратный
- Фильтр
- Предохранительный клапан
- Конденсатоотводчик
- Кованые Клапан Стальной
- Выделенный клапан хлора
- Новые продукты
Более длинный сильфонный клапан-преимущество
-
ножка:2-компонентный подъемный стержень с наружной резьбой, выполненной в рулоне; Соединительная муфта с сильфоном .
-
сильфон : Многослойные, полностью промытые сильфоны из нержавеющей стали, защищенные от кручения, рассчитанные на 10 000 циклов;
-
360º, что позволяет очищать примеси, которые могут переносить жидкость, чтобы закрыть крышку на разных поверхностях сиденья, в то же время она не передает вибрации на шток клапана.
-
Коническая пробка из упрочненной хромовой стали 1.4021 / AISI 420 или с твердым покрытием со стеллитом 6; Сиденье с твердым покрытием из нержавеющей стали 1.4370 / AISI 307 или стеллит 21